JDM - EZ Rods - 3/4"
JDM's new EZrods make it so much easier to adjust pinion angle, trailing arm lengths, toe, caster/camber, etc.
Simply back each set screw off 1/2 turn to make an adjustment. when utilizing set screws, you do not have to worry about the issue of misaligning the rod end when tightening a jam nut! If you don't like the set screw design, simply run your standard jam nut with them.
• 100% CNC machined out of chromoly steel.
• .100 wall.
• Stainless steel NYLON TIPPED set screws prevent damaged to the rod end.
• Available in 5/8 & 3/4 thread in increments from 4" to 18".
**The nylon tipped set screws are a wear item and it is recommended to buy a pack of spares.
SOLD BARE ROD - LESS SET SCREWS, ROD ENDS, JAM NUTS ( Photo shows example of rod with or without red end.)