ULTRA - Adjustable Low Friction Ball Joint - Lower Screw In -Large Thread -Small Stud
Our NEW adjustable ball joints are the newest edition to the ULTRA low friction ball joints. These ball joints can be taken apart for cleaning and maintenance. They feature a low profile design for more clearance to the wheel. The also have a gun drilled ball which not only makes it lighter, it allows a larger amount of grease. The ball is cross drilled for the grease to evenly distribute to the walls of the ball joint housing. The Ball/Stud is designed to automotive standards to the stud will bend before it breaks.
Ultra - Low Friction Ball Joint - Lower Screw-In • Large Thread, Small Stud • NOT FOR STREET USE - Off road use only • High Quality - affordably priced • Screw-in • Small or big tires - car raised or lowered, these ball joints will get the desired angles back where they need to be • 32° Swing angle to allow Maximum suspension travel • Taper fits lower eye on tubular spindle • Weighs 1.5 LBS
• Same stud taper as 081-1267 or Moog K-6141 • Same large thread as 081-1171 or Moog K-727 • Thread O.D. 2.020"
NOTE: To adjust simply tighten the cap until all end play is gone. Then back off 1/8 of a turn. Make sure to always reinstall the slotted washer and screws.
Ball Joint Adjustment steps: 1. Using a 3/32" allen wrench. loosen up the two set screws 2. Put the tool into the upper hex hole over the grease zerk 3. Turn the adjuster tool clockwise until its tight 4. Back it off slightly until the ball joint stud rotates smoothly 5. Line up the washer to desired location within the slots
